PA-28 Warrior II

@martyn I'll check it out later today. Thanks as always for the updates and keeping us in the loop.

@yankeetendy35 From what I can tell, mine has always seemed to be worse than anyone I've talked to, so it may be something in my settings or system. Going to see if their devs can help me figure it out, but thanks for the response.

Thanks for the feedback! Please see - https://community.justflight.com/topic/2476/update-change-logs-v0-3-0-released-edited-18-11-21/1

@walterbeech When you land at an airport with no transportation, you flip that switch to get a ride to base ops.

@docz Make sure the autopliot is turned off.

I to was a bit thrown at the lack of a control for the alt static air source.

@katchaplin Thanks. Your suggestion worked. However all I've done is reduce the ground aircraft density to zero and reduce the number of vehicles and workers to 50%. As you said, the problem then only comes on shutdown, and without the pilot appearing. At least I can use the aircraft whilst waiting for a fix.

@chalwk Better missing it now and learning where it is rather than not being able to find it when you really need it! (In the unlikely event of a virtual cabin fire )

@walterbeech I've submitted a ticket for this, they're aware of it for all the Arrow variants.

Martyn just replied in another thread that JF is updating the PA-28s next week and addressing this issue.

@skjjks Which specific autopilot functions aren't working? I am successfully using the default mappings for setting Heading, Course and Altitude using the rotary dial. I don't have any of the toggle switches mapped to autopilot functions... If you do want to map the toggle switches, I recommend using only SET commands or ON/OFF commands, and not TOGGLE commands. SET commands and ON/OFF commands are intended to be used with toggle switches. TOGGLE commands should only be mapped to momentary buttons, and never to toggle switches.

@dillet74 Not at all.

@delta558 said in Little things to add for the next update for realism: Mention flight dynamics and there is a wall of silence. It's been like that from the start, and I see no sign of it changing unfortunately. Oh, that really saddens me....I had be hoping for improvements to the flight model.

Alright, thanks for the input guys! I'll make note to start cross checking it more often on my end.

I did eventually change from Modern to Legacy Cockpit Interaction and that solved the issue of being unable to unlock the primer.

@vcapra1 @Sender46 You were both right. I've unbound the switch, now it works fine. Thanks for your help.

@walterbeech I'd add that a centre marker on the rudder trim would be very useful. If it doesn't have one in RW... I'd be reaching for the Tipex.

@katchaplin @RetiredMan93231 Yes, it's the IC switch! Thank you, gentlemen!