Turbo - No Fuel Flow

Zacke

6,5 gph on the EDM while priming.

Jonas.MV

This might be helpful for troubleshooting: in the stream of pilotdeviation, there was also no fuel flow in the non-turbo version: time index 00:34:40 https://www.twitch.tv/videos/2837089058

MatzeH84

FWIW I see fuel flow on the TN. But the needle is indeed quite sticky.

Ratman

I did another test and found something interesting.
This time, the fuel flow indication didn't increase again, even after tapping the gauge. The EDM showed that fuel flow was increasing normally, so the engine itself was receiving fuel correctly.
Since I had previously completed a flight where the gauge worked as expected, I tried to figure out what was causing the needle to stick. It seems to start sticking at around 16°C. By 20°C, the needle no longer moves upward at all, even if I tap on the gauge.

Voxen

What is strange is that I’m 100% sure to have seen the needle moving as expected at least once, most likely on the very first flight after purchase where I carefully followed the entire checklist.

Black Square

Hi, everyone. I looked into this more today, and found the obvious: The fuel flow gauge is highly non-linear at the very bottom of its scale. Since these real instruments are full of real mechanical eccentricities, I've just added a little piece of "cheater" code to help boost the fuel flow indication just enough to read on the scale. Hopefully that should help eliminate any confusion.

rightseat

@Black-Square said in Turbo - No Fuel Flow:

@Woolies Deploying the flight simulation software emergency response team now

Oh one one eight nine nine nine, eight eight one nine nine, nine one one nine, seven two five . . . . . . three.

I love the IT Crowd!

Black Square

@rightseat Remember: They're not just the emergency services, they're your emergency services

Voxen

I just noticed something today. First I started flying the turbo version of the commander and got that fuel flow needle not moving when priming (always). Then I switched to the normal version for a few flights, and there the needle is moving as expected. And today I have done another flight with the TC version and guess what: the needle was moving!
I can't find the logic there, but that is maybe something useful for you.

Voxen

Ok so with update 0.1.1 the issue remains. After installing the update and do a first test with the TC it worked fine, the needle was moving as expected. But today it does not. Tried 3 times on 3 new flights and that FF needle is not moving a bit.

Woolies

The change in new update seems to be good for me. Needle moves in NA and TC no problem.