Duke (Piston + Turbine) LVAR for MobiFlight
-
L:BKSQ_ShowCopilotInterior
I'm glad you got the altitude alteter working. I will have to think about why it works with that configuration to see if I have any further suggestions for you.
-
I'm encountering an issue where I've assigned the K:AP_PITCH_LEVELER_ON to my personal VS AP button (to switch to ATT mode), however when I do that GA lights up instead on the AP panel. Is there an error here in that VAR?
Also I don't understand how/why there is a AP GO-AROUND MODE (AUTO THROTTLE to GA), because I didn't think the Duke had any kind of auto throttle?
-
K:AP_PITCH_LEVELER_ON should do the trick, but it's possible that pressing it a second time in some circumstances could result in what you're seeing. Unfortunately, the MSFS variable to detect when go-around mode is activated is broken, so I've had to do some of my own process of elimination for the GA indicator. Looking at my code, I can see many questions I could ask in an attempt to get to the bottom of this, but let me start here: Is the pitch control mode working when you adjust the target pitch with L:var_AP_PitchKnob?
The Duke has no auto throttle, but the go-around mode can be used to position the flight director at 8° nose up with wings level for initial climb out.
-
No problem!
You can either use the native magneto events, such as "K:MAGNETO1_OFF", "K:MAGNETO1_LEFT", "K:MAGNETO1_RIGHT", "K:MAGNETO1_BOTH", "K:MAGNETO1_START" (there are more for different purposes)...
...or you can use "L:BKSQ_IgnitionPosition_1", which runs from 0-5. 5 is used for holding the start position without automatic return to both.
@Black-Square Bumping this thread because this is wrong and because the cockpit XML for piston duke needs fixing.
I've been trying to get both engines started through SimConnect for 4 hours. That is until I realized the cockpit XML is different for each engine mag switch. When using the behaviors variable list, "BKSQ_IgnitionPosition_1/2" is only writable 0-3. Setting it to 4 auto-reverts back to 3 and setting it to 5 does nothing but animate it to START while starting nothing.
i finally managed to start the left engine with A:GENERAL ENG STARTER:1 and K:SET_STARTER1_HELD. And start the right engine with A:GENERAL ENG STARTER:2 and K:MAGNETO2_START. Nothing else worked for me. I tried all the SimConnect magneto and starter set/toggle events and achieved nothing. The prop would just twitch or do nothing at all. The plane appears to require the usage of A:GENERAL ENG STARTER:x and doesn't respond to standalone K events.
Please correct this section:
-
Had a similar issue in the Bonanza regarding the Ignition Position not working right for positions 4 and 5. Nick has fixed it for a patch next week, hopefully the same fix can be applied to previous aircraft.
@jmarkows Yes, that change should solve any issues here too, with the 5 position now working as a start position with no spring return.
-
@jmarkows Yes, that change should solve any issues here too, with the 5 position now working as a start position with no spring return.
-
@Black-Square I'm open to testing anything prior to release.
@Tailhook Thanks for volunteering! Believe it or not, it should be as simple as doing the following find-and-replace on the main behaviors XML, and of course for BKSQ_IgnitionPosition_2, as well.
Find:
(L:BKSQ_IgnitionPosition_1, number) 4 ==
Replace:(L:BKSQ_IgnitionPosition_1, number) 4 >=
