PA-28R Turbo Arrow III/IV

@Tal-A Thanks for your advice.

Still not working after update. No mods, nothing in community folder. No errors. I have an open ticket, so hopefully we'll get it working soon. Just thought I'd follow-up on this thread.

@Travman said in Turbo Arrow Three completely nonfunctional after install:

Im getting the exact same thing. Mine is installed to D drive and I suspect its due to the long filename issue.

If I renamed the folder to a single letter then I get the EFB working with the Security Failure Message and the GPS loads, but the yoke is still fully deflected to the left and the instruments (horizon etc) are not working. I think some of the file names are still too long.

Thanks for the information. Please also contact the support team if you haven't already done so.

It does, but only just slightly. During run-up, when cycling the prop for example, a drop in 500rpm would yield about an 1” rise in manifold. For lower rpm reductions of a couple hundred rpms at a time, you may see perhaps a 1/2” rise and for rpm adjustments of 100 or less, MP needle movement is even noticeable. @ual763

I only mention it as 41 MP was right at the point I noticed FF dropping. Later I saw 41 in the engine.cfg and was like oh whats that?!?! lol

Also forgot part of the the chart

Screenshot (319).png

What happens if you try it in other (default) aircraft?

If you're using the mod, try it without the mod as well

@Cedric-Hunter

No discounts across platforms but there was a similar discount between the Arrow and Turbo in X-Plane.

All the Primer button does is momentarily activate the fuel pump on HIGH, as long as you hold the button down. Just turn on the fuel pump with your previously assigned Honeycomb switch...

@RetiredMan93231 you are right. With the latest version I can assign Set Electric fuel Pump 1 to a button on my Honeycomb but as you say you can´t select high and low. I would be musch better with a toggle function so every button press advances to the next state, then jumps back to the initial one. It can´t be impossible to work out.

/Thomas

hey it works now after update 0.1.1! thank you very much for that!

in my opinion the tail number could be bigger, it is quite small for my liking at the moment.

We're addressing this issue now. Thanks for the report!

Thnxks, ill try that. Should have take my time ! Anyway im in love in those Pipers.

Maybe you should add a screenshot to help understanding what issues you might have.
Also provide details about your graphics settings.

@Lemny
The mod for the turbo doesn't label the primer, it also changes the color and mislabels the Fuel pump switch. The modder is aware of it, but won't be able to fix it right away.

Fixed in the next update!