Throttle Increase/Decrease
-
Hi. I typically use Throttle 20%, 40%, 60%, 80% inputs and then Throttle Increase / Decrease to fine tune. Unfortunately, the Hawk does not allow me to use this sequence of inputs which I have not experience with other planes. For example, pressing Throttle 80% takes lever to 80% as expected but then pressing Throttle Decrease moves the lever all the way down to zero (vs. 79%). Is there an easy fix? Thx.
-
The throttle axis snapping between IDLE and 100% is likely the result of the control conflict. Do you perhaps have any controls assigned to "TOGGLE ENGINE 1 FUEL VALVE" or "SET ENGINE 1 FUEL VALVE"? Those assignments are used to move the throttle lever between the HP OFF and IDLE positions, so they could be 'fighting' against the throttle axis position.
Mark - Just Flight
-
Did you check the control assignments listed in my previous reply here? https://community.justflight.com/post/36792
There is a full list of non-standard control assignments at the end of the Hawk T1/A Advanced Trainer Operations Manual here: https://downloads.justflight.com/products/JFF003464/Hawk_MSFS_Manuals.zip
If the throttle behaviour persists, we would kindly recommend that you raise a ticket with Just Flight Support via the following link, and one of our support team will be able to assist with further troubleshooting: https://www.justflight.com/support
Mark - Just Flight
-
Did you check the control assignments listed in my previous reply here? https://community.justflight.com/post/36792
There is a full list of non-standard control assignments at the end of the Hawk T1/A Advanced Trainer Operations Manual here: https://downloads.justflight.com/products/JFF003464/Hawk_MSFS_Manuals.zip
If the throttle behaviour persists, we would kindly recommend that you raise a ticket with Just Flight Support via the following link, and one of our support team will be able to assist with further troubleshooting: https://www.justflight.com/support
Mark - Just Flight
@Mark H Hi Mark - thanks for your continued follow-up and support - I have a LOT of controls and when I went through all of my assignments and cleaned everything up to just stick and throttle it works. So I indeed did have something bound which was jamming the throttle.
My apologies for not doing a more thorough testing. Spent two hours in the plane already. Again thank you for your help.