Honeycomb Bravo with Black Square Caravan

[Deadmode]

Hi guys,

I have no issue setting my levers to throttle, prop and condition lever bindings to my liking and all is working as intended. I have no issue with the SWS Kodiak either.

However, the Black Square caravan is behaving VERY weird. Throttle Axis, or Throttle 1 Axis just travels the Beta range only, whilst Throttle Axis (0-100%) travels the entire range of the virtual lever, including the beta range.

This means that I cannot get the throttle to sit at idle when the bravo lever is at the detent.

How on earth am I meant to set this up?

[hangar_101]

@deadmode I setup all my levers using spad.next and they all work just fine. See if the setup below may help you figure out how to setup yours.

Throttle

Throttle Reverse

Propeller

Propeller Feather

Emergency Lever

Condition Lever
I use a VJOY setup for this lever. It's a bit more complicated, but it's all explained in detail in this following video

https://www.youtube.com/watch?v=xwdPurSOW1g

Regards,

Anderson

[Gabe777]

@anderson

The problem is full version of SpadNext is 80 quid.

Should we have to depend on 3rd Party apps ?

The new ATR has a built-in configurator.

May be nice to see this at some point.