Radar Altitude not working
-
I just noticed that the radar altitude instrument isn’t working — the needle doesn’t move during the approach. Am I missing something?
-
Did you check for a failure on the tablet, or accidentally pull the circuit breaker? I'll take a look later.
-
Did you check for a failure on the tablet, or accidentally pull the circuit breaker? I'll take a look later.
@Black-Square Yes, I did — both the tablet and the CB were good. I’ll check again on my next flight.
At 46’, you can see the radar altimeter is completely ‘dead’ — no needle movement
https://www.youtube.com/watch?v=a_4KS0GTN0A
-
Thanks for the video. I just checked and I can't reproduce this over here. The code is pretty simple, and I checked a couple possibilities. The only two ways it would stop working are if the electrical circuit fails, or if the RADIO HEIGHT SimVar isn't being populated from the simulator.
-
Thanks for the video. I just checked and I can't reproduce this over here. The code is pretty simple, and I checked a couple possibilities. The only two ways it would stop working are if the electrical circuit fails, or if the RADIO HEIGHT SimVar isn't being populated from the simulator.
@Black-Square I double‑checked the electrical circuits, circuit breakers, EFB failures, and radio height simvar. I tested both the cargo and passenger variants, used only the default livery, and even tapped the instrument glass a few times, but I still couldn’t get any needle movement. Any other ideas on what might be causing this issue?
