Missing LVARs for numerous switches

[Guenseli]

@escriba

START
1·(>K:TURBINE_IGNITION_SWITCH_SET2)
1·(>K:STARTER2_SET)

OFF
0·(>K:TURBINE_IGNITION_SWITCH_SET2)
0·(>K:STARTER2_SET)

MOTOR
0·(>K:TURBINE_IGNITION_SWITCH_SET2)
1·(>K:STARTER2_SET)

[Escriba]

@guenseli thanks, I never imagine. Now I can continue my binding

[Qazme]

Update:

Switches that the var can be set but doesn't reflect position in the cockpit

• EXT Power
• LEFT ENG ANTI-ICE
• RIGHT ENGINE ANTI-ICE
• CROSSFEED FLOW (Has position 7 but 144 isn't available)
• Avionics MASTER PWR - same vars can be set the switch does - however the actual function of powering the avionics doesn't happen. Hidden var in action.
• DEICE SINGLE
• STALL WARN
• PITOT LEFT
• PITOT RIGHT

Switches that have no VARs that can be set

• INVERTER 1&2
• ELEC HEATER
• AFT BLOWER
• CABIN MASTER
• BRAKE DEICE
• FUEL VENT LEFT
• FUEL VENT RIGHT

[meh1951]

Has there been any improvement to this issue?

[Voice of Reason]

From the developer...

'Yes, more convenience features for home cockpit builders were added in the last update. As it stands, all features of the Analog King Air are compatible with external hardware. Since the Analog King Air does not using WASM, all code for control bindings is accessible in AnalogKingAir.xml. For specific questions, please contact support, and they will direct the question to me. I haven't had a request that wasn't immediately possible yet!'

Support: https://support.justflight.com/support/home

[hangar_101]

@meh1951 see below for details on some of the information you may be looking for (KA setup)

Pitot

Crossfeed

Brake Deice

Ext Power

it works sometimes, but sometimes not - still trying to figure out what the problem is.

Ext Power On - this sequence will power on but no switch movement

Ext Power Off

Stall Warn

Cabin Master

Avionics

For Avionics Off use the same code just set VAR_AVIONICSMASTERSWITCH to 0

Eng Anti-Ice

Set LVAR:XMLVAR_INTERSEP_L to 1 (Anti-Ice ON)
Use LVAR:XMLVAR_INTERSEP_R for Right Eng Anti-Ice

Aft Blower

Elec Heater

Inverter


It's like a toggle command, use the same sequence to turn it OFF

I hope it helps you!

Regards

Anderson

[meh1951]

@anderson Thanks buddy let me try to digest this.

[Gabe777]

@guenseli Mr G .... the Streamdeck master 👍💕

[Olivier A.]

HI Anderson

Thank you so much for your help which is really appreciated !!

A quick question when you entry several data. Hereafter your example for Avionic Master Switch:

I am not sure where I put 17 & 4 ?! Value for event are properly completed ?

[Olivier A.]

Hello Anderson

Further to my previous post, I've figured out why it wasn't working! I put "Yes" for end of processing and now it is working very well