B58 Switch Assignments
-
Is there a list for the switches offsets / assignments for either FSUIPC, SPAD.NEXT or MOBIFLIGHT
I'm trying to assign the L & R Alternators, fuel boost pumps, magnetos / starters.i can get the alternators to work via kb commands, but not separate left or right
i can get magnetos / starter to work, but causes the gear to retract at random and jump around.I don't use a kb or mouse one setup on ramp, this new b58 real as it looks n feels, requires a mouse n kb to use, don't recall a kb n mouse in a real b58????
-
Is there a list for the switches offsets / assignments for either FSUIPC, SPAD.NEXT or MOBIFLIGHT
I'm trying to assign the L & R Alternators, fuel boost pumps, magnetos / starters.i can get the alternators to work via kb commands, but not separate left or right
i can get magnetos / starter to work, but causes the gear to retract at random and jump around.I don't use a kb or mouse one setup on ramp, this new b58 real as it looks n feels, requires a mouse n kb to use, don't recall a kb n mouse in a real b58????
@tech2123 Here you go, extensive help, direct from the developer...
'The alternators in the Analog Baron should respond to the native Input events, K:TOGGLE_ALTERNATOR2, and K:TOGGLE_ALTERNATOR2. If that does not work, the Analog Baron specific L:Vars, BKSQ_alternatorSwitch_L, and BKSQ_alternatorSwitch_R, can be used.
For the ignition switches, here is a note from the manual that covers all the possible native events. As a last resort, L:BKSQ_IgnitionPosition_1 and L:BKSQ_IgnitionPosition_2 can be set from 0 to 4.
Event ID bindings have been added for the ignition switch, alternator, and standby alternator. This should allow users to use their hardware without having to change event bindings. The following are examples of acceptable key events: MAGNETO_OFF, MAGNETO_LEFT, MAGNETO_RIGHT, MAGNETO_BOTH, MAGNETO_START, MAGNETO1_OFF, MAGNETO1_LEFT, MAGNETO1_RIGHT, MAGNETO1_BOTH, MAGNETO1_START, SET_STARTER1_HELD, SET_STARTER_ALL_HELD, TOGGLE_ALL_STARTERS, TOGGLE_STARTER1, MAGNETO_INCR, MAGNETO_DECR, MAGNETO1_INCR, MAGNETO1_DECR, TOGGLE_MASTER_ALTERNATOR, TOGGLE_MASTER_BATTERY_ALTERNATOR, TOGGLE_ALTERNATOR1, ALTERNATOR_OFF, ALTERNATOR_ON, TOGGLE_ALTERNATOR2.
For the fuel pumps, circuit 4 and 5 control whether the pumps are on or off (A:CIRCUIT SWITCH ON:4, bool), and L:var_FUEL_Switch_Pump_1 control the state of the switch. 0=Off, 1=Low, 2=High.'
-
Thank you very much for this list I appreciate it I have tried a lot of these commands to no avail, with FSUipc, spad.next but the lvar's one does work.
I did manage to get the alternators going and I did manage to get the fuel boost pumps going I will attempt the Magneto's tonight with the lvars section.
I now using spad.next with the lvars,