Steam Gauge Overhaul

@raptyrone Can confirm. I've seen that, too ... Oliver

@bentree Hi From the MAP page, click the CDI to GPS mode. Should follow the magenta line when you select NAV mode on the AP

@n38tm Never mind, I wasn't opening the bleed valves.

@bellocchio2 Hi, I'm no expert but I suspect ambient air temperature, air pressure and other weather conditions may be a factor here; I did find an example of ITT exceeding the normal operating redline (but not the start redline) during start-up: https://www.youtube.com/watch?v=xXuOBdSr4uc

@simon Thanks for explaining!

@n38tm said in v0.1.1a Engines wont start, no prop animation, High Idle kills: @captainmd My 530 is working and engine issue seems somewhat resolved. Takes a long time for engine to start turning. No... The Turboprop engines on the King air are free turbines. Simple explained, the free turbine consist of the compressor, whivh is directly coupled to the gasproducer turbine. This assembly works more or less like a normal jet engine. The propeller is via a gearbox connected to the free turbine, which isn´t connected to the gas producer section described above (Jet engine). The exhaust gas flow from the gasproducer drives the free turbine i.e the propeller. When You start the engine, only the gas producer starts rotating - You can hear the engine spool up. Once the gas flow is sufficient to drive the free turbine, the propeller starts to rotate.

@simon Awesome, thank you!

@voice-of-reason Thank you for the update! Much appreciated!!!

@simon ah, thx ...!

@simon Yes, I know, but B:Vars can't be controlled. (they can, but with a complicated workaround) Hope you consider variables for us! thx

@airnorth Perhaps worth checking you have the CDI source switch set to RNAV, and the KNS-80 is in RNV/ENR or RNV/APR modes. VOR or VOR/PAR modes will not appear to be correct RNAV readings, as they render the unit equivalent to a NAV3 radio by providing course deviation information relative to the physical VOR station. Hope this helps! If not, perhaps if you can send us a video or some screenshots by raising a ticket https://support.justflight.com/support/tickets/new and we'll pass them onto the developer to look at?

At the upper left side of the GNS 530 bezel, there's a small, round switch marked "C". This should turn the unit on.

Ok... Page 15 of manual, shame on me, it's ok now.

landing gear key binding was the problem