Steam Gauge Overhaul

@simon ah, thx ...!

@simon Yes, I know, but B:Vars can't be controlled. (they can, but with a complicated workaround) Hope you consider variables for us! thx

@airnorth Perhaps worth checking you have the CDI source switch set to RNAV, and the KNS-80 is in RNV/ENR or RNV/APR modes. VOR or VOR/PAR modes will not appear to be correct RNAV readings, as they render the unit equivalent to a NAV3 radio by providing course deviation information relative to the physical VOR station. Hope this helps! If not, perhaps if you can send us a video or some screenshots by raising a ticket https://support.justflight.com/support/tickets/new and we'll pass them onto the developer to look at?

At the upper left side of the GNS 530 bezel, there's a small, round switch marked "C". This should turn the unit on.

Ok... Page 15 of manual, shame on me, it's ok now.

landing gear key binding was the problem

Update: ohh I had to fix the engines in the Bendix Radar menu thingie since engine damage is persistent. All is well now.

The only way I could get liveries to work was to add a model folder and model.cfg file to the steps in the Manual.

NOTAM There is a mandatory update for the PMS50 GTN750 All is OK now Have good flights JLUC LFST

@derek Many thanks!

It seems it installs on MSFS community only. Yet, to use the AddonsLinker I moved the KA350 folder to the dedicated community folder without issues - yet one has to remember to move it back to the original community folder prior to an update!

Got her, thank you very much Pascal

v1.3 "New custom implementation of the KAP140 Autopilot. The previously recommended mod presented an incompatibility with the TDS GTN 750 after Sim Update 10 that resulted in modes getting stuck, and altitude hold mode failing to maintain altitude. No autopilot mod is required or recommended for the Analog Caravan any more." Well this settles it once and for all Looking forward to the King Air tomorrow!

@voice-of-reason thank you for your help. i stopped using the kap140 mod based on some info i obtained on the msfs forums so that's probably what did the trick for me. regardless, appreciate you taking the time to respond.

@daparkersd Avionics screens can be popped out the same as any other MSFS aircraft.

@olivier-a Triggering events can be accomplished by monitoring with Spad.Next, or by looking in AnalogCaravan.xml. AnalogCaravan.xml also has a header with many important L:Vars for home cockpit builders, such as turbine engine values. Avionics screens can be popped out the same as any other MSFS aircraft.

@scoobyx Thanks for that mate, great to know and I'll check him out. Cheers Warwick

@pier74 This is an answer direct from the developer for you. If you're following the checklists... it could be that there's no fuel in the aircraft. Asobo resets the fuel to zero sometimes when you reload aircraft. It could be that you're using external hardware or events that incorrectly set the fuel selectors, such as to "LEFT", instead of "LEFT MAIN". Are you sure you're positioning the starter switch to "START", and not "MOTOR"? For this, check to see if the green annunciator "IGNITION ON" is illuminated while starting. Hope this helps.