RJ will not accelerate past V2+10 after takeoff

av8r172

After takeoff, reaching acceleration altitude, and increasing the speed window to 210 (RJ100), the FD bars continue to pitch for about 15 degrees. Therefore the aircraft does not accelerate and allow me to clean up. LVL CHG has no effect on pitch unless I disengage and reengage LVL CHG several times. Then it seems to "wake up".

I did a clean reinstall of the product which solved it temporarily (for a few flights), but now it's back. I haven't changed any of my procedures.

av8r172

Here is a video I made. Even if I push thrust manually to full, it doesn't accelerate. LVL CHG has no effect.

https://www.youtube.com/watch?v=o5K9oqT2cOI

av8r172

Note that LVL CHG behaves as expected after flaps are retracted to 0

av8r172

Also notice that V cross (V+) is not displayed on the speed tape, even though I have set it on the TRP.

Mark

Could I kindly ask you to raise a support ticket with Just Flight Support via the following link: https://www.justflight.com/support

If you could include all the information you provided in this forum thread, including any screenshots/videos you have of the behaviour, then our support team will be best suited to assist with this.

Mark - Just Flight

av8r172

@Mark, Thank you for the reply. I submitted a ticket 9 days ago, but have not received any response. I will certain update the ticket with the information I have provided here.

Mark

That's definitely not what we want to hear. We apologise that you've been waiting that long for a reply.

I have forwarded this on to our support team to see if they can locate the ticket, and they should be in touch soon.

Mark - Just Flight

Neal

This has been happening to me, but only since I joined the SU4 beta, so put it down to that. Can I ask if you are on the Beta?

av8r172

@Neal Not on the beta, never have been. For me, it seems to be tied to Beyond ATC. When I'm running that program, IAS doesn't behave properly. When not using BATC, works fine.

I've noticed several videos on youtube where it's not working for other people either. Eagerly awaiting an update for this.

Neal

Thanks for that. I have just bought BATC, which coincided with a new SU4 beta release. I'll give it a go without BATC.