Altitude selection

[xdbusy]

Hi there, whenever I select an altitude in the RJ it either goes too low/too high by roughly 300ft. So say I select 5000 it will stop +/- 300ft above or below I was wondering if I was doing something wrong? Thank you

[Mark]

This isn't something I am able to replicate on my side, so if the behaviour persists, could I kindly ask you to raise a ticket with Just Flight Support via the following link: https://www.justflight.com/support

In the ticket, if you're able to provide any further information about the behaviour, ideally including the flight plan, the phase of the flight where the behaviour occurred, as well as any related screenshots/videos, then our support team will be best positioned to assist with further troubleshooting, or to pass on to the development team for further investigation.

Mark - Just Flight