Can't dial course 1
-
What could have happened? I don't use SPAD or any third party control apps. I only assign AP disconnect, flaps, speedbrake, trim, gear, and a couple other things in the MSFS menu for aircraft inputs from hardware. I haven't changed anything with that setup since I installed 2020 two years ago. All of the sudden I load up the RJ and I cannot change the captain course from 000. I looked at all my bindings, unplugged hardware, checked every part of the flight deck that could even remotely apply (ILS/VOR frequency, et cetera). It is broke immediately on startup. I don't use state saving either. The only third party apps are fs2ff for ForeFlight, FSLTL, and GSX.
Do I simply need to uninstall and reinstall? I'm not sure how it just stopped working.
-
Hi,
I had the same thing happen earlier this week.
I reinstalled the airplane, but I think the cause was not with the plane.
Do you use the TDS GTN750Xi by any chance?
I think that was the cause of the issue, as with their latest version, the problem went away.
See also in their discord, the problem with the stuck NAV1 course is discussed there. -
Oh wow, yes, I have the TDS GTN. How weird. Ok, I'll see if I can fix it! Thanks!
-
Just update the TDS to the latest version and you’re good to go!
-
M Mark referenced this topic
