Engines wont start msfs2020
-
So i updated the RJ avro but now i cant start the engines. No fuel injection. Before the update all was dine no problems with engine start. Someone have the same problem?
I also tested it when I set the aircraft state to ready to takeoff no engine start -
I'm seeing this behavior in 2024 as well - using the same startup procedure that worked previously prior to the RJ update in 2020, engine N1 will do the initial spoolup, but introducing fuel does not activate iginition (fuel pumps are set to on). Not sure what is going wrong here...
-
I'm seeing this behavior in 2024 as well - using the same startup procedure that worked previously prior to the RJ update in 2020, engine N1 will do the initial spoolup, but introducing fuel does not activate iginition (fuel pumps are set to on). Not sure what is going wrong here...
@desertdragon yes they wont start. I dont know why but its not a user error.
-
I'm seeing this behavior in 2024 as well - using the same startup procedure that worked previously prior to the RJ update in 2020, engine N1 will do the initial spoolup, but introducing fuel does not activate iginition (fuel pumps are set to on). Not sure what is going wrong here...
@desertdragon i rolled back to the last update now the engines are working but not with the newest update
-
i have just purchased the RJ today - followed the FLYING THE RJ section from manual and engines wont get past n2 25% and no increase on EGT - any ideas? (xbox
-
I'm thinking I may have a conflicted key bindings. I'm using a airbus thrustmaster yoke and throttle.
I've set the throttle up as per another thread on here and also set key bindings to go from fuel cut off too idle. -
happy to report all user error (my fault) had the ign selector on the TM Airbus Throttle set to Crank. but it in normal position andd EGT spooled up