Thrustmaster Throttles proble,
-
Can anyone help me to properly setup the Thrustmaster TCA Airbus throttles. I tried AXIS 0-100% and Axis 1/2/3/4 and they don't work properly
Thanks
Nikita
-
Thank you for the Info, my throttle do move but they don't go from 0%-100% like in PMDG 737 as an example. They move half way up and don't go fully idle. I binded throttles to Axis1/2 and Axis3/4
-
That sounds like it may be sensitivity curve related. If you go to MSFS Options > Control Options, then click on your throttle quadrant and click 'Sensitivity'. Could you double check that each of your throttle axis has the settings shown in the following screenshot:
Mark - Just Flight
-
Yes that was the issue. Thank you! But how can I go from flight idle to ground idle with my throttle. When I put the throttles all the way to 0, it stays in flight idle position and not ground idle
-
Unlike the 146, the RJ doesn't have seperate positions for flight idle and ground idle, it just has an "IDLE" position (labelled on the pedestal).
Perhaps you are referring to the FUEL ON / FUEL OFF positions? In which case the throttles can be moved between those two positions either by clicking the latches on the rear face of each throttle, or by using the SET ENGINE X FUEL VALVE control assignments (where "X" is the engine number).
Mark - Just Flight
