Engines 1 and 2 not starting
-
When selecting ready for take off it would appear engines 1 and 2 are not running and I cannot get the HP cocks to move from closed to open. Any ideas folks, I was just hoping to get quickly in the air.
-
That sounds like there may be a conflict with the controller assignments that are holding the throttles in the HP Cocks SHUT position.
Do you perhaps have a throttle quadrant that has fuel levers on it, and are they set to SHUT? If so, try setting those to OPEN and see if that resolves the issue.
Alternatively, you can check if anything on your hardware is controlling the SET ENGINE 1 FUEL VALVE, SET ENGINE 2 FUEL VALVE. etc control assignments via MSFS Options > Controls Options.
Mark - Just Flight
-
That sounds like there may be a conflict with the controller assignments that are holding the throttles in the HP Cocks SHUT position.
Do you perhaps have a throttle quadrant that has fuel levers on it, and are they set to SHUT? If so, try setting those to OPEN and see if that resolves the issue.
Alternatively, you can check if anything on your hardware is controlling the SET ENGINE 1 FUEL VALVE, SET ENGINE 2 FUEL VALVE. etc control assignments via MSFS Options > Controls Options.
Mark - Just Flight
@Mark thanks I'll check when next near my PC in two weeks. I do have a throttle quadrant ( Airbus) so I'll disconnect it and see what happens. This product looks amazing. Very well done Just Flight!
