Could not engage AP
-
Hello not sure if anyone else might be having this issue but in the 200QT after departure I could not engage AP the mouse won’t even change to a clickable but all other AP functions I could click, and they would go green but could not engage AP. I followed the tutorial step by step so I wouldn’t think I missed something.
Thanks for any help.
-
The AP master and yaw damper are on the pedestal.
-
@fab10 I’m so stupid, gosh thank you!!!
-
The only reason I knew that is because I did the very same thing, LOL!
-
Everyone is going to do the same thing!
The only reason I hadn't posted the question here was I learned my Toggle AP button works, so I didn't think much of the fact that the spot wasn't clickable, and I've since read enough of the manual to have found the center console button.
Don't disconnect via the center console button, though, because it's not normally how the AP is disconnected so you WILL get a constant audio warning. Use the yoke disconnect or a Toggle/Disconnect AP bind in MSFS.
-
@jmarkows Thanks for the bit about disconnecting. I kept getting the constant tone when disconnecting with that button, but not every time so I assumed it was a bug. Using a Toggle AP binding in MSFS still causes the constant warning sometimes so I still think it may be a bug
-
@n293wk just in case I described it incorrectly, here's where I got it from: https://forums.flightsimulator.com/t/released-just-flight-bae146-the-little-jumbojet-april-29th/502682/526