nav sound receiver
-
If I flight with classical radios, VOR frequencies work. I dont hear any beep sound however. I activated nav1 switch in the panel just above the radios. If I switch to tds I can hear the beep, but if I go back to classic radio beep dissapears. Am I misssing something?. I havent seen any volume for the radio signal, just the classic activate switches.
Thx -
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
-
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
@Black-Square thx man. Found it!!! It only works while pressed. (the VC-ID)
-
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
-
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
@Black-Square Nick, can u confirm if u designed as a only work while pressed? The manual says is a toggle button (the VC-ID) but the moment u release the button the beep stops...
Is not a big deal, just curious.Thx again and best wishes with the release and bug fixes.
I really like it and just did a flight using the RNAV. -
@Black-Square Nick, can u confirm if u designed as a only work while pressed? The manual says is a toggle button (the VC-ID) but the moment u release the button the beep stops...
Is not a big deal, just curious.Thx again and best wishes with the release and bug fixes.
I really like it and just did a flight using the RNAV.@pequenyo Fixed. Thanks.
-
The volume of the morse identifier from a VOR is very quiet compared to other sounds even with the volume full up. I can just hear it on the ground with engine off but in the air it is very hard to hear. Same with listening on both NAV1 and NAV2.
Oh and same for listening to ADF code.
https://www.twitch.tv/woolies
-
The volume of the morse identifier from a VOR is very quiet compared to other sounds even with the volume full up. I can just hear it on the ground with engine off but in the air it is very hard to hear. Same with listening on both NAV1 and NAV2.
Oh and same for listening to ADF code.
@Woolies It's a real shame, isn't it? It's been like that since the debut of MSFS 2020.
