<![CDATA[nav sound receiver]]>If I flight with classical radios, VOR frequencies work. I dont hear any beep sound however. I activated nav1 switch in the panel just above the radios. If I switch to tds I can hear the beep, but if I go back to classic radio beep dissapears. Am I misssing something?. I havent seen any volume for the radio signal, just the classic activate switches.
Thx

]]>https://community.justflight.com/topic/11093/nav-sound-receiverRSS for NodeFri, 31 Jul 2026 10:28:30 GMTThu, 30 Jul 2026 19:06:18 GMT60<![CDATA[Reply to nav sound receiver on Thu, 30 Jul 2026 20:19:23 GMT]]>@Black-Square thx man. Found it!!! It only works while pressed. (the VC-ID)

]]>https://community.justflight.com/post/52977https://community.justflight.com/post/52977Thu, 30 Jul 2026 20:19:23 GMT<![CDATA[Reply to nav sound receiver on Thu, 30 Jul 2026 19:43:55 GMT]]>I'm not 100% sure this is your problem, but here are two excerpts from the manual:

The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.

NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.

]]>https://community.justflight.com/post/52973https://community.justflight.com/post/52973Thu, 30 Jul 2026 19:43:55 GMT