nav sound receiver
-
If I flight with classical radios, VOR frequencies work. I dont hear any beep sound however. I activated nav1 switch in the panel just above the radios. If I switch to tds I can hear the beep, but if I go back to classic radio beep dissapears. Am I misssing something?. I havent seen any volume for the radio signal, just the classic activate switches.
Thx -
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
-
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
@Black-Square thx man. Found it!!! It only works while pressed. (the VC-ID)
-
I'm not 100% sure this is your problem, but here are two excerpts from the manual:
The large white button labeled “VC-ID” activates the morse identifier signal from the NAV receiver. The small knobs are used to adjust the volume of the COM radio, and the NAV morse identifier.
NOTE: To hear an audible radio station identifier, “VC-ID” button must be toggled, and the appropriate NAV receiver toggle switch must be activated on the AMR-350 Audio Panel.
