Right Magneto cuts engine
PA-28-181 Archer III
2
Posts
1
Posters
718
Views
1
Watching
-
I have the Honeycomb Alpha Yoke and when I use the Honeycomb configurator I set the following:
MAGNETO LEFT = MAGNETO1_LEFT
MAGNETO RIGHT = MAGNEO1_RIGHT
MAGNETO BOTH = MAGNETO1_BOTH
ENGINE OFF = MAGNETO1_OFFHowever when I select MAGNETO RIGHT on the yoke's magneto knob the engine cuts out and shuts down. The Magneto switch in the virtual cockpit works correctly (e.g. selecting Magneto Right the RPM drops, selecting Magneto Left the RPM drops) but I have not been able to successfully map MAGNETO RIGHT.
-
I have discovered the following events control the magnetos:
Right Magneto = LEFT_LOWER_magneto_right (LVAR)
Left magneto = LEFT_LOWER_magneto_left (LVAR)However I do not know how to configure this, knowing this information!