Unable to Load Aircraft
-
I have a new laptop with Windows 10 Home x64. I have a fresh install of X-Plane 11 direct install. I have downloaded and copied across the folder from the JF BAe146 Aircraft download zip. X-Plane runs ok, loads the standard aircraft, downloads update including scenery, etc. But it won't load/run the 146 aircraft.
Basically XP11 gets to the point where it says "Loading Aircraft/JF_BAe_146_v1.0.5/JF_BAe_146_100.scf." and then progress stops. Eventually I hit Ctrl-Alt-Del and Cancel to find windows prompting that XP11 has hung and offering to kill the instance. At least twice I've had to power cycle the laptop. I've tried -200 and -300 aircraft with the same problem. I've tried loading another aircraft (successfully) and then switching across to the JF146 with the same result.
Any assistance would be appreciated. I've registered a ticket with support as well.
Thanks, Regards, Ken
-
I have a new laptop with Windows 10 Home x64. I have a fresh install of X-Plane 11 direct install. I have downloaded and copied across the folder from the JF BAe146 Aircraft download zip. X-Plane runs ok, loads the standard aircraft, downloads update including scenery, etc. But it won't load/run the 146 aircraft.
Basically XP11 gets to the point where it says "Loading Aircraft/JF_BAe_146_v1.0.5/JF_BAe_146_100.scf." and then progress stops. Eventually I hit Ctrl-Alt-Del and Cancel to find windows prompting that XP11 has hung and offering to kill the instance. At least twice I've had to power cycle the laptop. I've tried -200 and -300 aircraft with the same problem. I've tried loading another aircraft (successfully) and then switching across to the JF146 with the same result.
Any assistance would be appreciated. I've registered a ticket with support as well.
Thanks, Regards, Ken
-
@KenPascoe Hi Ken, could you attach your log.txt found in the X-plane 11 root directory ? Kind Regards Harry
-
Ok, so as it turns out - my problem was patience. I was giving the progress bar stuck at a certain point 5 minutes to progress. When I gave it nearly ten - it started moving again and the simulation loads.
My problem now is that the simulation runs for about 5-10 minutes then crashes out, repeatedly. But I will play with it some more and generate some repeatable results, capture the log files and start another post.
Thanks for the replies.
Ken
-
Ok, so as it turns out - my problem was patience. I was giving the progress bar stuck at a certain point 5 minutes to progress. When I gave it nearly ten - it started moving again and the simulation loads.
My problem now is that the simulation runs for about 5-10 minutes then crashes out, repeatedly. But I will play with it some more and generate some repeatable results, capture the log files and start another post.
Thanks for the replies.
Ken
