Piper Arrow audio panel
-
Hello,
I can't get the audio panel to work. I cannot get it to send and receive on COM1 and monitor COM2. With the MIC set to COM1, no matter what i change on the audio panel, COM1 is always coming through, and i get absolutely nothing out of COM2. NAV1 audio seems to work as expected.
As far as i understand, the middle position on the audio panel should be the off position. Moving the AUTO switch either to phone or speaker (not sure what the in-sim functional difference is) will automatically route whatever receiver is paired with the selected MIC channel to the headset. Moving any of the other switches (COM1, COM2, etc) to any other position than the middle should also route them to the headset.
This just doesn’t happen. No matter what i do, i cannot silence COM1 with MIC set to COM1, and i cannot hear COM2 with the MIC set to COM1. If i set MIC to COM2, COM2 now works and i can’t hear COM1. The NAV receivers seem to work just fine, albeit at a very low volume.
Can anyone confirm this?
Thank you.
-
So... can no one confirm this?
-
There is more info on this issue on this thread... https://community.justflight.com/topic/1822/pa28r-arrow-audio-panel/8
-
There is more info on this issue on this thread... https://community.justflight.com/topic/1822/pa28r-arrow-audio-panel/8
@RetiredMan93231 Thanks for pointing that out.
