TBM 850

patchadams502003

I just installed the TBM 850 and the digits in my altimeter are missing along with the digits in my bottom left OAT gauge.

jetpro

@patchadams502003 Same problem here. Also, my pitot heat will not turn on.

Melon

@patchadams502003 do you have the Honeycomb? If so I'm guessing you have Avionics Bus bound. Try unbinding that or toggling it on. Tested it on one of my control bind profiles and toggling the Avonics Bus 1 switch on and off would turn those gauges on and off (and the GPS too).

patchadams502003

@melon I’ll give that a try, thank you so much for the suggestion

patchadams502003

@jetpro try unbinding any toggle switches from your honeycomb bravo throttle quadrant…unbinding avionics master fixed my problem 🙂

patchadams502003

@melon that appears to have fixed my issue, thank you again. 😀

Voice of Reason

A quick answer from the dev on this point:

'I just wanted to let you know that it is indeed the Honeycomb bindings that cause this problem. I really should have seen that coming and mitigated the problem before release, though, since many of the reported issues in my aircraft are caused by Honeycomb. I have made some changes to the aircraft for the next update that will render this a non-issue, but other bindings on the Honeycomb may still cause problems that I'm not aware of.'

I hope that helps.

Darth Patzer

@patchadams502003 Hello, I've got the same problem but not with no Honeycomb. I've got Logitech Switch Panel and I use spad.next. The problem also turn off GTN750 but not others GPS. Well... I don't know what to do...