Overstressed aircraft at rotation - Bonanza normally aspirated

Ronnie

First of all, thx for great aircraft !
There's so much to discover and having fun with !

What am I missing ?

If spawn to the runway, and takeoff from there, all works fine. I'm taking about getting airborne and start climbing.
If I do a cold & dark, I'll get a "overstressed aircraft" message, a few seconds after lifting up the nose slightly.

throttle fully forward
props full
mixure rich
flaps one notch down
trim slightly above U
avionics ON
primary alternator ON
rotating gently just after 71 knots

I must be missing something, can't work it out.

I've also checked/reset any faults from the "radar", all good and nothing broken.
Storm Window is closed.

By the way, pls don't open the Storm Window while flying, it will end up in tragedy.
I had to test today, don't do it.

I'm on Windows 11, running FS2020

So from cold & dark I'm unable to get a successful flight, from spawning to the runway, it works.

I'm running out of ideas, pls help.
Warm regards,
Ronnie Sutherland

emmaflic

I had that happen with the turbine one on 2024. I had to turn aircraft damage off and did a few flights and open n close the storm window . So far its not happed again on cold n dark .. I turned damage back on.

jmarkows

Turn off all crash and stress damage except engine damage.

Ronnie

Turning stress damage OFF in the SIM settings, just a workaround.
To be not really a solution, just a Band-Aid.
If I spawn to the runway, then everything is fine. I can rotate and climb as normal.
I’d like to keep stress damage on HARD in the SIM settings
Do a cold & dark
Perform a normal rotate and climb, without damaging the aircraft