Doubts about ailerons and circuit breakers

[RICMAND]

Hi all, I'm studying the TBM 850 on the POH and I have some doubts about these two:

1. in the POH I found that "A rudder / roll combination spring-type system induces roll deflection at the time of pedals movement and vice versa" (chapter 7.4). I tryed but when I move the rudder pedals the ailerons don't move. Is this the meaning of this section of the chapter, or I am wrong?
2. again, in the same chapter: "Roll trim tab electrical circuit is protected by the ”AIL-TRIM” circuit breaker". If I try to disingage this circuit breaker the roll trim continue to work (and this is for all the electrical trims, pitch and rudder.

Regards.

[Black Square]

I was actually unaware of the rudder-to-aileron mixer, which is surprising, given its prominent listing in the flight controls section. I'll see about adding that for the next update.

Electric trims do always work in my aircraft, because most hardware inputs directly set the trim variables via the native commands. It's only possible to intercept some of these events, and it's also relatively "dangerous" to do so, because it's such an essential input. As you can imagine I sometimes I have to make difficult decisions about features that might go wrong for even 1 of 1,000 users depending on their setups.

[RICMAND]

Ok for the first answer. About the second I don't understand. My question is: my electric trims work also in my aircraft. But I expect that if I disengage the relative "circuit breakers" the electric trim stop to work. This don't happen.