Engines auto start when connecting to GPU
-
After completing a flight, I shut the airplane completely down. So far all normal. Once I connect to ground power, both engines begin motoring as if the starter switches were activated, however I double checked, the starters are both off. The only way to stop the engines is to disconnect ground power.
Any ideas?
-
I assume the starter switches were centered, and not in the motor-only position? If so, then perhaps a hardware binding conflict? If it’s nothing obvious, then I can walk you though troubleshooting the electrical system, but I would say that it’s very unlikely this is a frequently encountered bug with Starship itself.
-
Thanks for the quick response! I shut the sim down and restarted it, the issue disappeared and systems now operate normally and the Hobbs meter works now. Go figure. Thanks for the great aircraft!!!
