AP Nav mode issue
-
While in AP Nav mode the signal will drop for less than a second causing the HSI Nav flag to flash on then off again. This happens every several seconds in the turbine duke. Using the GTNXi from TDS. No failures are showing active. Doesn’t do this while in heading mode. Any idea what might be causing this?
-
Just checked the code, and the HSI NAV flag uses the simulation variable
A:HSI CDI NEEDLE VALID, as opposed to anything TDS specific. This means that it could be either an issue with your TDS installation (such as multiple instances running at the same time, which I have seen), or it could be something else on the simulator side of things, trying to write to the same variable. I would suggest temporarily emptying your Community folder of everything except the TDS and see if this solves your problem. Let me know if you need any more suggestions. -
Interesting. The Turbine Duke and Piston Duke's code should be identical. I can't tell you what that means for your specific issue yet, but it might be some clue in the future. Please let me know what you find. I'll be away from my desk for the next couple of days, but I will get back to you as soon as I can if you need anything else from me. The Just Flight support team is also always there if you need a hand.
