Analog Baron in FS24
-
I've tried copying the Analog Baron folder into the Community folder in FS24, and I wanted to ask a question.
Has anyone been able to get this plane working in FS24? When I try to start a flight with it in Free Flight, the simulator freezes and doesn't go past the overhead view with wind and the white spinning circle. There is no CTD, I can go back, and if I switch to another plane it works.
If anyone has been able to use it in FS24 I would appreciate knowing how you configured it to get it to work. Thanks and regards -
While this is not something that I'm officially endorsing before I have a chance to experiment with it specifically, I have heard many reports of my Steam Gauge Overhaul aircraft being 100% functional (after the last 2024 update) using this method.
@lilycrose Can you please tell me what switches and lights are giving you trouble? I haven't seen anything like that with the TBM in 2024, at least without copying the 2020 default TBM (as my 2024 update for the TBM and Velocity will not require copying any 2020 assets).
-
None of the exterior lights came on for me when I checked them during my preflight. And the Aux Boost Pump would only cycle between ON and AUTO, it wouldn't shut off. I never got to the point of trying to fly it, so not sure what else may not have worked correctly. I'm going to try another flight shortly, see if I find anything else. I'll send an update if anything else doesn't seem to be working.
Just to add a bit more, the fuel switch is wonky. If I set it to ON, the annunciator shows AUTO, if I set it to auto the pressure fluctuates and then the engine dies. But it's not completely consistent, sometimes I can set it to the switches as they should be, but most of the time it seemed like I had to set it to ON to get the AUTO light. Something to look at perhaps, for an update. And the exterior lights still didnt work for me.
Another item I almost forgot, every time I turn on the Left Landing Light, it pops the circuit breaker. But there are no failures in the tablet, and I can reset the CB and it will work until the next time I try to turn it on.
This is all for the TBM 850, not the Analog aircraft, just continuing the thread started earlier.
-
I just tried moving the Analog Baron over along with the default Asobo Baron from MSFS2020 and MSFS2024 did not like it. It would just hang at 94%-97% loading on startup. Removing both allowed '24 to fully load again. I have not tried any of the others (I own the Baron, Bonanza, Kingair, and Caravan).
-
@RoughLandings You have to move the base Asobo aircraft over as well, if you haven't done that.
-
@lilycrose, I did. No joy.
