Baron Icing Switches
-
May I ask what controllers you're setting up?
@GunStrauss said in Baron Icing Switches:
May I ask what controllers you're setting up?
I'm sorry mate I don't understand what you mean by "controller".
-
@djw4250, here you go:
I can't take credit for most of this but it works well for me. I think it is from the Spad creator, not sure but I found it on YouTube either way.
The mode selector knob has nothing assigned to it. The rotary encoder dial on the right side uses conditions to check the position of the mode selector knob:
Heading Mode Button:
Nav Mode Button:
Approach Mode Button:
Reverse Mode Button - I used it to swap the CDI mode:
Altitude Mode Button:
Vertical Speed Mode Button:
IAS Mode Button - I use it to swap between the altimeter and vertical speed input modes on the KAS 297B. It is not a true toggle, but long press for one mode, short press for the other:
The rotary encoder dial - note the conditions for each event that check the position of the left selector knob:
Autopilot Master Button:
@RoughLandings thanks for sharing these setups, they are very helpful.
You can also share all spad.next specific settings of yours using the publish snippet option. Once you have done it just let people know the user/snippet name here in the forum and people can download them to their spad.next directly.
It's a good option to help those who are not that familiar with coding spad.next.Below an example
-
Input device
@GunStrauss toggle switch (SPDT) wired to a Leo Bodnar board.
-
@RoughLandings thanks for sharing these setups, they are very helpful.
You can also share all spad.next specific settings of yours using the publish snippet option. Once you have done it just let people know the user/snippet name here in the forum and people can download them to their spad.next directly.
It's a good option to help those who are not that familiar with coding spad.next.Below an example
@hangar_101, I do have a published snippet for the Bravo and Analog Baron. The ID number to look it up in Spad is 10854. It's my only published snippet so far but has the autopilot settings I posted above.
