Honecomb bind to C208
-
I want to bind my honecomb to C208.
I have two questions
What is the binding axis for that emergency handrail on the far left?
For the condition lever I want to bind the bottom of one of the axes "trigger key 27" to cut off, when the lever is up the condition lever will come to the center position.
Can anyone share some config files，thx? -
I want to bind my honecomb to C208.
I have two questions
What is the binding axis for that emergency handrail on the far left?
For the condition lever I want to bind the bottom of one of the axes "trigger key 27" to cut off, when the lever is up the condition lever will come to the center position.
Can anyone share some config files，thx?@casperchen0211 for the emergency handrail use this LVAR
VAR_EMERGENCYPOWERLEVERPOSITION
Below an example of this axis setup using Spad.Next
-
I want to bind my honecomb to C208.
I have two questions
What is the binding axis for that emergency handrail on the far left?
For the condition lever I want to bind the bottom of one of the axes "trigger key 27" to cut off, when the lever is up the condition lever will come to the center position.
Can anyone share some config files，thx?@casperchen0211 for the condition lever below follows the events you can use. I setup them using a lever axis though, you just need to assign the cutoff event to the button you want to use instead.
CUT OFF
LOW IDLE
HIGH IDLE
