No fuel flow climb and so low vacuum
-
Hello everyone, I am writing this message because I have not been able to start the Caravan Analog for at least two weeks. I follow the entire checklist perfectly, I cleared the entire community folder to avoid conflicts (the 320Fenix, the 737/700, the 414 Chancellor, the Maddog X by Leonardo, the GTN750Xi, nothing else remain) and I checked not to have active failures.
Practically when putting the fuel condition lever on low idle, I have no fuel flow climb, which remains at 0 as before starting the engine and obviously after a few minutes the propeller stops. Do you have any kind suggestions for me? Thanks in advance. -
Hello everyone, I am writing this message because I have not been able to start the Caravan Analog for at least two weeks. I follow the entire checklist perfectly, I cleared the entire community folder to avoid conflicts (the 320Fenix, the 737/700, the 414 Chancellor, the Maddog X by Leonardo, the GTN750Xi, nothing else remain) and I checked not to have active failures.
Practically when putting the fuel condition lever on low idle, I have no fuel flow climb, which remains at 0 as before starting the engine and obviously after a few minutes the propeller stops. Do you have any kind suggestions for me? Thanks in advance.@pier74 This is an answer direct from the developer for you.
If you're following the checklists... it could be that there's no fuel in the aircraft. Asobo resets the fuel to zero sometimes when you reload aircraft. It could be that you're using external hardware or events that incorrectly set the fuel selectors, such as to "LEFT", instead of "LEFT MAIN". Are you sure you're positioning the starter switch to "START", and not "MOTOR"? For this, check to see if the green annunciator "IGNITION ON" is illuminated while starting.
Hope this helps.