Logitech Switch panel with the Arrow

Cdr_Maverick

@anderson SPAD.neXt has debugging tools and monitors where you can also find out which variables are available. Also when adding actions you can choose:

Tigerclaw

@Cdr_Maverick Thank you, I will look into this later today. Much appreciated 🙂

hangar_101

@Tigerclaw it took me some time to figure out the reason I could not see the LVAR in SpadNext, if you are still facing the same issue the tip below may save you sometime

Kaukinen

I can now see those LVAR parameters in Spadnext. But are those values only "read-only"? If I try to set those parameters on switch panel with "Change Data value", value does not change. How can I set those values?

hangar_101

@Kaukinen you may change the LVARs values, below follows an example, I have the Avionics switch configure to turn on/off GPS, increase Com1 and Nav1 volume, also turn on kx175 com2 and nav2 and increase their volume as well, and do the same for the other instruments

Kaukinen

@anderson YesH! Thank you very many, those parameters I was rly looking for...

It was very frustrating to swhitch on all those coms and navs before flight.

hangar_101

@Kaukinen I have published my SpadNext PA28R Arrow III (JF) profile. Check it out!

hangar_101

For your information, Spadnext LVARs do not work with new World Update IV due ASOBO issue.

Got the information below from official Spadnext channel

hangar_101

Spadnext LVAR bridge fix available @ MS Store

sydel7912

@Martyn said in Logitech Switch panel with the Arrow:

The SET commands should be supported following our update but we'll get the ON/OFF commands added.

Hello Martyn,
Any news on this support?
I just bought a switch panel and it works fine with any default Asobo aircraft but with the Arrow, it's completely messed up.
Turning on one switch turns off another one, so unusable for me.
Cheers, Sylvain