RNAV using NAV1 or NAV2 receiver/ILS 400 doesn't save state

Zacke

Hey guys,

the RNAV uses NAV1 and NAV2 receivers for waypoint 1 and waypoint 2. The manual states RNAV uses only NAV1 for both waypoints.

And the ILS 400 is always on with a new session regardless of the state you left it.

Regards,
Zacke

Black Square

@Zacke said in RNAV using NAV1 or NAV2 receiver/ILS 400 doesn't save state:

the RNAV uses NAV1 and NAV2 receivers for waypoint 1 and waypoint 2.

What do you mean? I don't believe it does, unless I missed updating a file.

The ILS 400 should retain its state along with the rest of the avionics, as long as you have the avionics state saving option selected.

Zacke

Hi Nick,

when I switch waypoints with RNAV it also switches the NAV receivers as reference.

The ILS 400 is always on eve if I had switched it off last session. All state saving options enabled.

Black Square

I fixed the RNAV. Single character mistake. I'm not sure what to say about the ILS 400, however. I'm looking at that variable in the state saving matrix right now. I'll try it later.

Zacke

Thanks a lot! No biggies here.