Suggestions for a possible v1.4
-
I've had a little time with v1.3 and overall I'm really pleased with the changes so far. A great plane is now even better.
I'm sure a few things will come to light so thought we could collate suggestions here, should the Duke receive any future updates. Realistically, I appreciate it may well not receive any more (except emergency bug fixes if Asobo move the goalposts) and that's fine. There's no expectation, only boundless enthusiasm!
A couple I am sure I have mentioned before but didn't make it:
-
I would love for the walkaround items to be independent of each other, i.e. the left engine plugs shoudn't also remove the right engine plugs. Removing the pitot covers near the nose shouldn't also remove the static port covers near the tail. Left chocks & right chocks too. I appreciate that complicates matters with the toggle switches in the tablet, but it would make the walkaround more meaningful - and the cost of forgetting one more consequential.
-
Unfortunately, there's still a typo (missing 'T' in 'limitations') on the label in the nose compartment (sorry)

-
Prior to starting the piston Duke, positive fuel flow is obtained with mixture rich and pump on, even with the throttle at idle. I assume that's a deliberate and accurate change, but thought it worth a sense-check because it's unusual in my experience.
-
I'd love if the piston Duke and Grand Duke were treated separately for state saving. They are presented separately in the aircraft selection screen after all. I fly the Grand Duke "for real" and use the regular Duke for "experimentation" sometimes, but state saving is shared between them. Ask me how I know! Per livery or tail number is even better, but I appreciate it might be a lot more complexity and not really worth it.
-
With the changes in the piston engine modelling, it seems that the props can only ever stop in one position, with one blade in the 12 o'clock position. This might be correct to the real aircraft (and many photos seem to show it like this, though not all), but... I preferred when the props stopped in a less rigid position. I don't have tons of time on v1.3 yet, so stand to be corrected. But if it's accurate, I'll take it

Side note: I've always preferred the look of a static 3-bladed prop when there's a blade near the 6 o'clock position rather than 12 o'clock. I just find it more aesthetically pleasing. Is it just me?
As ever, I don't mean to detract from the great release that v1.3 is, and I'm more than happy with what I already have.
-
-
@jmarkows I had, and the pattern is clear. But that doesn't intuitively make me understand exactly why it rests like that. I know it's an equilibrium between the various pressure states of the cylinders. No issue there, I just don't remember it happening quite so precisely before and nothing fundamental to the engine was changed that I remember, just some animation improvements - so I thought I'd mention it.
I realise a 6-cylinder engine will have a 720° cycle so it'll roughly stop around 120° increments. But I don't know if the prop is always installed in a particular keyed alignment with the crankshaft and cylinders, or if it just depends on the orientation chosen by the fitter. Funny that flight sims make us curious about such minor details!