Inertial Separator and Gear Lever configuration problem SPAD.next
-
Hello,
I've been enjoying the Caravan Professional quite a bit. I've got a nice SPAD.next profile set up for myself. The only then that I can't seem to get working, and it's bugging me quite a bit, is that I can't seem to get the inertial separator and the gear lever (for the amphibian version) to work.
I've tried multiple configurations, including the L:XMLVAR_InterSep (0 and 1) and the L:var_WaterRudderHandle (set 0 and 100), but the levers in the cockpit don't move.
Any suggestions?
-
I forget what the cause was, but I have fixed the inertial separator handle not animating with the variable for the next update. The water rudder handle should work as-is, however. I made some significant changes to the water rudder behavior in v1.2, so please be sure you have the latest version. Do you have hardware bound to the water rudder perhaps? If none of that works, feel free to send me some more information or screenshots, and we can investigate further.
-
Much appreciated! I will need to check the profile again with the amphibian to see if I can get it to work. What I wonder, haven’t got the time to test it in flight, doesn’t the lever move while on the ground? I’ll be looking forward to the updated version with fix for the inertial separator. That will make the operation before take-off and after landing so much more convenient! I’ve bee flying the Grand Caravan an awful lot the last two days, as our VA just acquired our first Caravan and I’ve been flying it back to base while operating a lot of OnAir jobs. It’s an absolute dream to fly!
