TG Problem Using P3Dv5.1
-
I have been using TGv1.1.1.8 just fine with P3Dv4.5 for a long time. Last week I installed P3Dv5.1 and tried to compile flights for it today. When I try to open the manual or compile v5.1 I get the Unhandled exception error window. When I start the compiler it starts running even with the Unhandled error but it never finished running, just stuck on the spinning wheel after 2 horus. Also on the home page P3Dv5 still has the red x box. I ran the Setup Wizard 3 different times to add v5.1 to the sim list but the home page still shows it with the red box and when I start the wizard it always has v5 not listed. In case it matters my v5.1 is on a different drive from TG. Is there something else I need to do first for TG to find P3Dv5.1?
Do I need to reinstall TG for v5.1 to work with it? Any other suggestions how to move forward with TG & P3Dv5.1?
Thanks,
Jerry -
@HondaJet
Run the Setup Wizard again you can do this without re-installing through the Options tab.
When you get to the detect sim screen like this.
https://www.flickr.com/photos/154944674@N05/50586064776/in/dateposted-public/
Check the bottom box has the right location for P3Dv5 dont worry about 5.1, if it`s not correct use the folder icon to point it to your P3Dv5 install, it may detect old sim entry hit the red button to cancel them as i have done then hit the green button you should see this.
https://www.flickr.com/photos/154944674@N05/50016546106/in/dateposted-public/
And complete if correct.