No engine start.

Martyn

Great, thanks for letting us know

Jpol

Same issue today. Get no fuel to the engines even with the fuel on.

Upon further testing, it seems it wont work on first load, you need to load, restart the sim and then it works with every variant.

Mark

I'm not aware of us receiving any other reports of this at this stage, but we'll continue to monitor this in case it starts to become more widely reported.

I know I've had issues with various products in the past where I've had FUEL VALVE or STARTER assignments unknowingly assigned to my hardware, and that can cause engine start issues.

Mark - Just Flight

Jpol

I've confirmed multiple times that i have no controller assignments set blocking the start. It's an odd issue for sure. Will try to reinstall both the 70 and 100 to see if that helps and will report back.

Jpol

Reinstall of the aircrafts seems to have worked. Will report back if anything reappears.

mari8it

same problem here no keys assigned to fuel but engine 1 won't start stuck at 25% with ff44 i will try to restart sim

CV409i

I unfortunately experienced the same issue this morning on the Fokker 70 VH-NUO MSFS 2024. No assigned bindings for fuel cut off. Have done two other flights with the Fokker with no issue.

Engine start up will not accept fuel and the N2 sits at 25%. Resolved the issue by restarting the Sim.

JGreen5278

Encountering this issue as well. Moreso recently after updating to 1.1 int he Fokker 100

ibanez971

Same issue, I've tried 3 or 4 times. Haven't been able to fly yet. I haven't tried restarting the sim, I just fly something else.

AlysonJohnson

I’m experiencing the same issue. Have restarted the sim multiple times.

Even setting the status to ready for take off has no fuel flowing to engine one

JGreen5278

@ibanez971

Try loading the aircraft like normal, cold and dark then selecting restart in the main menu not a permanent solution but perhaps it’ll at least get you
going.

JF John

As well as making sure there aren't any control assignments interfering with the fuel values, can you confirm you've waited the 2 mins required after APU start for bleed pressure to become available? If you continue to have issues please contact support.

speedbrake22

@JF-John the 2 min is not in the docs (as far as I can see), but when I had the same issue earlier today there was bleed air coming from the apu

bjratchf

Make sure the ignition selector is not in AUTO...

Crabby

Anytime you do a first load of an aircraft, close out back to desktop and restart. This ensures that all the WASM loads properly. Sometimes you don't have to, sometimes you do. Best practice is to close and restart so you don't waste a bunch of time hunting down a problem that really doesn't exist.