Baron engines at 0% health when loading into the sim
-
Hello everyone,
Loving both the Bonanza and Baron but Baron engines are at 0% health whenever I load into an airport, repair always needed to get the engines to work, previous flight engines were at 100%.Any ideas why this is happening?
Thanks.
-
Hello everyone,
Loving both the Bonanza and Baron but Baron engines are at 0% health whenever I load into an airport, repair always needed to get the engines to work, previous flight engines were at 100%.Any ideas why this is happening?
Thanks.
@flipside05us After repairing your engines, try going into the sim menu and pressing Restart to restart the flight, and then end the flight. That should hopefully save your engine state.
There’s a bug with SU4 that broke the native state saving that Black Square aircraft use, amongst some other developers. Above is the workaround to get the state to save.
If you follow the Restart -> End Flight process every time, the state saving should reflect in each future session. You’ll only need to do that when you’re done with your flying session and want to close the sim, not every time you land and want to take off again in the same session.
-
Thanks for the tip, will certainly try that next time I fly, but why does it start at 0%? Is that a bug su4 introduced as well?
-
Thanks for the tip, will certainly try that next time I fly, but why does it start at 0%? Is that a bug su4 introduced as well?
@flipside05us that one I’m not so sure about, I haven’t had that happen yet to me on SU 4. Could be the fist time the aircraft was loaded something caused them to get set to 0 and it stuck.