Oxygen Leak and Alt Static Air
-
Two different questions. I refilled my oxygen but now I have a constant sound of air leaking. Doesnt matter if I turn the oxygen knob on or off. What am I missing?
Starting to get familiar with the checklist and when i got to the Alternate Static Air Normal...I had no idea where to find this on the panel?
-
In the Dukes, the only time oxygen should ever be flowing is when the green stripe is visible on the oxygen control knob. It takes a moment to fade after closing the valve. If you continue to see this, feel free to send me one of your excellent videos of the situation.
The alternate static source switch is on the copilot's side wall. It's the locking toggle switch protected by the red cover.
-
After reading your post, I trouble shot it like I had to do with the climate axis. I couldnt use the filter trick like I did for the climate levers so I ended up reassigning it from an axis to a switch. That now has the air noise on when the knob is green and on and fades to quiet and off when the knob is off.
Thanks again.
-
After reading your post, I trouble shot it like I had to do with the climate axis. I couldnt use the filter trick like I did for the climate levers so I ended up reassigning it from an axis to a switch. That now has the air noise on when the knob is green and on and fades to quiet and off when the knob is off.
Thanks again.
@Kilstorm If you're using AAO and want to control it with axis, what you could do, is set the axis range to be from 0 to 1 and enable the integer checkbox, that way AAO will only send values 0 and 1 if the axis is below or above half point (assuming the variable for the oxygen knob takes values 0 and 1, didn't check).
-
@Kilstorm If you're using AAO and want to control it with axis, what you could do, is set the axis range to be from 0 to 1 and enable the integer checkbox, that way AAO will only send values 0 and 1 if the axis is below or above half point (assuming the variable for the oxygen knob takes values 0 and 1, didn't check).
@Randolf said in Oxygen Leak and Alt Static Air:
@Kilstorm If you're using AAO and want to control it with axis, what you could do, is set the axis range to be from 0 to 1 and enable the integer checkbox, that way AAO will only send values 0 and 1 if the axis is below or above half point (assuming the variable for the oxygen knob takes values 0 and 1, didn't check).
Thanks. I will give that a try. The value is Boolean so I dont know what that means but do understand what you are saying so Ill try that and reply back.
