Speedbrake and blowback issue

[pap]

HI,
I put the speedbrake on an axis in MSFS.
When over 190kts I need to move the handle of the speedbrake more than 50% of the axis in order to get some drag.
Whereas in the F28 the handle start to move also when I am over 50% of the range of the axis.

The result is that when passing below 190kts the drag increase from 30% to 80% in one sec whithout any change in my handle

Hope this is clear enough ;-)
This is not a big deal but decreasing speed below 190kts is a bit touchy when using the speedbrake on an axis
May be I did something wrong in the configuration...
I thought that over 190Kts, starting moving the handle thanks to an axis, should also to move the handle in the F28 up to the blowback effect
Thanks
Pascal

[pap]

Hi,
In fact I did some new tests et read again about this speedbrake blowback in the F28 and it really work as it should...!!
Sorry my bad !
It then simulate very well indeed.
Thank you
Pascal