Landing Gear problem

FBumm

Hi,

the landing gear doesn´t work on the BAE after update. Hydrolics etc. I checked. Any idea what else it could be?

Thanks for your help!

Martyn

@fbumm I can't see anything obviously wrong in your screenshot. Was this happening when attempting to retract the gear after take-off? Does it occur if you start a flight on the runway or use the 'Ready for Takeoff' EFB state?

edwardthepilot

@fbumm Make sure your speed is below the gear retraction speed limit, 205kts I believe.

K5NRK

Hi All. I am having a similar problem as when on approach. I deploy my landing gear and he nose gear doesn't come down. Also I cannot deploy my flaps. I followed the procedures when on descent turning on PTU pump, turning off engine air and firing up the APU. Note that I experience this problem when starting the aircraft in the Turn-Around state. Anyone else have this issue and/or solution? Many thanks in advance for any help. Greatly enjoying the BaE146.

K5NRK

@k5nrk I since flew another flight. I logged onto a rwy (BGKK which doesn't have ramps) instead of a ramp spot. After the aircraft came up, I requested from ready for takeoff (which is what you get when you sign onto a rwy) to cold and dark. Still the landing the nose gear did not deploy and the flaps did not extend. I think this condition may happen when signing onto a rwy, However if you sign on at a ramp you will get normal gear and flap extension.

K5NRK

@k5nrk Well I tried via Cold and Dark and on the ramp and still can't deploy my nose gear and extend my flaps! I will now try by getting entirely out of MSFS2020 and re-entering. Stay tuned for details.

K5NRK

@k5nrk After experiencing this issue in various configuration modes, I uninstalled my BaE146 in MSFS2020 and then reinstalled V1.5. That seemed to work as I now get nose gear and flap extension during approach. Perhaps there were some conflicts when installing V1.5 over V1.2? Looks like the issue is resolved and I can now enjoy flying this a/c again.