KN 62A Frequency Selection 0.05 digit
Sorry, here is a better explanation of my issuu:
How can i select the 0.05MHz digit of the KN 62A in the Arrow III/IV in MSFS with the mouse?
The tutorial on page 64 want's me to select 114.35, but i can't adjust the 0.05 digit. The manual on page 33 says "pull" / "push" the inner knob to change from from 0.1 MHz to 0.05 MHz. How can i do this?
Is there anyone can help me?
Thanks a lot!!
@chrisoak It works for me.
Slider set to FREQ.
Tune to 114 with outer knob.
Tune to .30 with inner knob.
Put mouse pointer over end of inner knob and mouse pointer should change to a pointing finger (if you don't see the pointing finger your mouse pointer is not in the right position and this won't work, or maybe you have something else going on preventing this).
Left mouse click with the pointing finger and you should see the inner knob pull out and at the same time the .30 change to .35.
Then rotating the inner knob left or right will change in increments of 0.10 from 0.35 (e.g. to .25, .45, etc.).
Left clicking again on the end of the inner knob will push it back in (which would change it back to 114.30, etc.)
@sender46 Many, many thanks for your patient, Sender46!
I have thousend times followed your advice, but the pointing finger will not appear. I have even reinstalled the files but nothing changed.
Unfortunately i cannot attache my short video i have made about what allways happend.
I think, it's my own special problem with my system :(
btw: i'm an experienced computer and flightsimulator User and i should not fail on common knob handling. But!! Who knows :)