Cannot start up engine
-
@supersym not sure what the mouse problem is, however for the switch panel to work you'll need to do this: https://support.justflight.com/support/solutions/articles/17000118190-honeycomb-yoke-start-issue
It says Honeycomb but the effect is the same.
-
@supersym not sure what the mouse problem is, however for the switch panel to work you'll need to do this: https://support.justflight.com/support/solutions/articles/17000118190-honeycomb-yoke-start-issue
It says Honeycomb but the effect is the same.
-
@supersym says it right there, replace the existing engines.cfg with the _Honeycomb one. Move that into the folder and rename it engines.cfg.
-
@jmarkows ok I will try
But do you think it will work because I've the same issue if I use the mouse ?@supersym I have the same Logitech panel and it fixed it for me. I don't know what you're doing or not doing with the mouse, but the engines.cfg_Honeycomb shortens the number of cranks necessary to start it because the Logitech/Honeycomb switches don't stay in start for very long and you can't change that.
-
@supersym I have the same Logitech panel and it fixed it for me. I don't know what you're doing or not doing with the mouse, but the engines.cfg_Honeycomb shortens the number of cranks necessary to start it because the Logitech/Honeycomb switches don't stay in start for very long and you can't change that.
-
@curts It's in the aircraft folder:
\Packages\Community\justflight-aircraft-pa28-warrior-ii\SimObjects\Airplanes\JF_PA28_Warrior_II\
-
Hi !
It was a big mistake from me !
the tank's valave was off ! I didn't see it very well
But rename the file seems to get me CTD.
So first Put the tank on Left or Right and I can start the engine...
Apologize for loosing your time :frowning_face: -
Hi !
It was a big mistake from me !
the tank's valave was off ! I didn't see it very well
But rename the file seems to get me CTD.
So first Put the tank on Left or Right and I can start the engine...
Apologize for loosing your time :frowning_face:finaly,
I need the file to start up with my logiteck panel !
I need too to open the valve of course :squinting_face_with_tongue:
Without the file I can start up with the mouse. The mistake was the valve.
May be last time the data were still in memory, and deleting the file did'nt erase the data of the driver in memory
I tried several times today, no CTD...
May be CTD are depending something else...
See you later :smiling_face:
