The new UFMC and GTN 750 in the BAE 146
lewisananda last edited by
As of Sept. 16, 2021 I have the upgraded FMC's installed for the X-plane 11 BAE 146 including the UFMC and the reality GTN 750. I know how to use the GTN 750 but will there be a tutorial on how to use the UFMC? Thanks, Lewis
@lewisananda For starters, there is a manual in the documentation folder.
@lewisananda could you please tell me where to download the upgraded FMC?
dipperdolphin last edited by
@marco1212 Update it via skunkcrafts.
Is there a changelog around?
@dipperdolphin From the included changelog.rtf:
-Included UFMC (Custom FMC) support
-Included support for 3rd party RealityXP GTN750 in 3D cockpit
-Fixed windshield reflections (no more "ghosting" of taxi lines or exterior reflections)
-Improved ASI bug manipulator logic
-Reconfigured positions of instrument displays for better use of panel texture space
-Created click spot on weather radar screen for 2D pop-up window.
-Improvements to TMS: Pressing an active mode or TOGA button will return TMS to standby and freeze actuators in place
-Improved TMS actuator simulation: blue up-arrows and white down-arrows will correctly show whether the pilot needs to increase or decrease throttles
-TMS actuators will now remain centered when the thrust levers are at idle
-TMS actuators movement rate is no longer dependent on frame rate
-Fixed engines #3 and #4 low oil temperature in flight after a cold-and-dark start
-Added custom commands for the throttle latches, eg. "thranda/switches/ThrottleLatch0"
-Improved yaw damper control authority
-Changed pulsating beacon to flashing beacon
-Improved Engine Overspeed test: If N1 is between 26 and 40%, this will shut down the engine. This can be reset by either re-starting the engine, or powering down the ESS DC bus.
-Fixed missing FUEL TRANSFER annunciators. They will now properly indicate the center tank transfer valve positions.
-Add missing altitude alert tones
-Fixed ghosting markers on clock
-Re-mapped TOGA button on throttles
-Oxygen test now requires oxygen valve to be open.
-Added Ground Power Unit model.
-Fixed potential negative values for airbrake angle when cold and dark with a tail wind.
-Added limiters to the fuel clickspots in the tablet to prevent over-filling.
-Reduced fuel flow at idle
-Fixed transponder code resetting to previous value if ENT key was pressed after entering the code
-Fixed interior of combi cargo version (Left Door closed from the inside)
-Fixed TMS error when adjusting TGT temp in TGT mode.
-Allowing for volume adjustments on vol knobs that are pushed in.
Glasairmell last edited by
How do you get the GTN to work please. From the plugin menu it is grayed out. Saving flight plans in UFMC format from Navigraph is a challenge. Using Little Navmap to convert them atm.