Pa28 problem
-
Hello. I have a problem with Just Flight Piper Arrow 3 to MFS2020. when it loads, the airport cannot avionics, bugs 1 and 2 do not work. Landing lights also not a choice. if I run the plane through the tablet the plane works but the lights don't work. if, on the other hand, it loads a lonely start on the starting plate, everything will be done. What could be wrong?
-
The first thing you should always suspect when you see any kind of odd behavior or problems is all of the other add-ons you have installed... including any liveries or mods to the interior color of this aircraft. I recommend you start by temporarily removing everything else from the Community folder, except for this aircraft, and then see if the problems go away.
-
The first thing you should always suspect when you see any kind of odd behavior or problems is all of the other add-ons you have installed... including any liveries or mods to the interior color of this aircraft. I recommend you start by temporarily removing everything else from the Community folder, except for this aircraft, and then see if the problems go away.
-
@RetiredMan93231 i dont have anything in community. First time after instalstion works good but second time its buged. 0 volts, fuel pump and light dont work.
@boss88, This sounds like a dead battery...
-
If the battery volts read 0, click on Recharge Battery to restore the battery voltage to normal.
-
Select the Ready for Takeoff state to make sure all of the switches are in the flight configuration.
-
Check the amps meter and flip the Generator Switch to make sure it is working and charging the battery.
-
-
@boss88 You are correct... the Recharge Battery function appears to be broken. I will submit a Bug report on it.
