Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

State saving does not remember GTN750

PA-28R Arrow III

5

5

529

Log in to reply

E
Evillian last edited by

When my last panel was the GNS530 it remembers and uses that panel. This does not work for the GTN750, it reverts to classic panel.
1 Reply Last reply
Reply Quote 3
Tigerclaw last edited by

Confirmed here too. Just goes back to the GPS100 when you close with the GNS750 active. (For me that’s the full activated version of the 750)
1 Reply Last reply
Reply Quote 0
petesmiffy last edited by

Same for me too.
1 Reply Last reply
Reply Quote 0
C
captain744 last edited by

This post is deleted!
1 Reply Last reply
Reply Quote 0
Martyn JF Staff last edited by

This will be fixed in the next update.
1 Reply Last reply
Reply Quote 0

1 / 1