HP Fuel Valve control via Hardware
-
Goal: Drive the HP Fuel Valves through CLOSED/START/RUN via hardware inputs (ideally my Honeycomb Bravo axes + reverse detent buttons)
Issue:
When I spawn in Cold/Dark my HP Fuel Valves are always in the OPEN state.
I manually move them with mouse scroll wheel to CLOSED, and then I use my mouse wheel to articulate them to START and OPEN during engine startup. But I would like to drive these with my Honeycomb Bravo hardware.I have tried every Fuel Valve (nominal, 1, 2) binding available "On" and "Off" and "SET" to get them to articulate but none of those mappings move the valve models in the cockpit and I can't tell if they're doing anything behind the scenes in the sim.
I have ensured that none of my HOTAS equipment is mapped to any fuel or engine systems except for Throttle 1 Axis and Throttle 2 Axis, so I shouldn't have any other controls overriding my attempt to drive the F28 HP Fuel Valves through the Fuel Valve 1/2 commands (recommended bindings in the manual).
Has anyone had success driving the HP Fuel Valves with hardware bindings?