146 State Saving Not Working?

[SteveKane]

Just got the 146 a few days ago, after flying the Avro RJ for several months. Fun going old-school!

It seems like the State Saving feature is not working. Here's what I'm seeing (FS2020):

1. I have State Saving enabled in the EFB.
2. After landing and parking, I shut down all systems and switches, disconnect ground power, turn off batteries to fully shut the plane down, exit the flight to the main menu (FS2020). Sometimes I'll leave a random switch (i.e. Flight Director) turned on just to see if the state is captured.
3. Start a new flight with the same model/livery, perhaps at the previous airfield/stand, perhaps somewhere else. The plane always seems to be in a turnaround state, with batteries on, APU + APU GEN on, etc. I usually just hit the "Cold and Dark" button, which resets everything to a pristine state, but that's too easy.

Any ideas? I'm pretty sure that the Avro RJ behaves as expected when it comes to state saving.

[Mark]

I've just tried this on my side and the state is correctly saving, so it is possible the state saving logic may have just gotten confused.

The next time you load a flight in the 146 could you try the following:

1. Disable 'State Saving' on the EFB
2. Exit to the Main Menu
3. Load a new flight in the 146
4. Enabled 'State Saving' on the EFB

That should reset the state saving and hopefully, should get it working for you on future flights.

Mark - Just Flight

[SteveKane]

Thanks, Mark, that seemed to work. All good now!